User avatar
masukomi @masukomi@connectified.com
11mo
Good news, Bad news.

2nd CO2 sensor build.

Good news:
- My solder job didn't break anything.
- I was able to see & flash the device.
- I was able to "interview" the device.

Bad news:
- I wasn't able to actually add it to the zigbee network
- It comes up. takes a reading, disconnects and - as far as I can tell - never comes back until i plug it in again. Isn't visible as a USB device even.
- I was only able to "interview" it once.
two circuit boards with soldered headers on a breadboard with jumper wires. there are lit LEDs on both boards
a screenshot from Home assistant showing that it interviewed the device and started to “configure” it.
a photo of my screen showing the log output which ends with “Terminal disconnected: NetworkError: Then device has been lost.”
2
0
0
0
User avatar
pathetic piss kitten @kitten@elizabeth.cat
11mo
@masukomi you only soldered the pins you were going to use? ​:blobcatgiggle:​ that's lazy!
1
0
1
0
User avatar
masukomi @masukomi@connectified.com
11mo
@kitten nah. That’s me believing that each additional soldering attempt is an opportunity for me to fuck something up ;)
2
0
0
0
User avatar
masukomi @masukomi@connectified.com
11mo
@kitten i have zero confidence in my abilities here.
0
0
0
0
User avatar
pathetic piss kitten @kitten@elizabeth.cat
11mo
@masukomi oh, I see...
0
0
1
0